BASKET
0You have 0 items in your basket.
VAT total | £0.00 |
Total Goods (inc VAT) | £0.00 |
These cutters are for Trend Craft Dovetail Jigs.D 19.1 mmC 25 mmOL 65 mmA 97 degreesShank Diameter 1/2 inch
Allows templates to be placed either on top or the bottom of the material, for ease of routing.
Template thickness should be 5mm thicker than cut length of cutter.Can be used to rout both tenons and housings.D 3/4 inchD 19.1 mmC 11.1 mmB 19.1 mm
Two flute TC cutter giving good chip clearance.D 3/4 inchD 19.1 mmC 19 mmOL 51 mmShank Diameter 1/4 inch
The glazing bar ovolo cutter is bearing guided to speed setting-up and to enable curved frames to be moulded.D 28 mmC 19 mmB 12.7 mmR 10 mmOverall length 70.5 mmShank Diameter 1/4 inch
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.Two flutes give a clean finish to cut edges.All cutters above and including 9.5mm diameter, have TCT plunge centre...
A two fluted cutter to give a clean finish to the cut edges.Use only on professional routers with 80mm deep plunge and suitable one piece multi-slit collet to ensure safe cutter retraction into base.D...
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.Two flutes give a clean finish to cut edges.All cutters above and including 9.5mm diameter, have TCT plunge centre...
Heavy duty arbor with spacers for 12mm bore slotters with or without bearings.OL 84.5 mmSpigot dia. 12 mmSpigot length incl thread 45 mmSpigot thread length 20 mmDiameter 18.5 mm
Recessing cutter will accommodate the Schlegel Aquamac 21 or Exitex Aquatex A10 seal.D 46.3 mmD2 34.3 mmC 10.3 mmC2 2.7 mmOL 90 mmB 28.6 mm
These slotters have a 12mm clear bore to enable them to be mounted at any position on the arbor in combination with spacers, with or without a bearing.D 50 mmBore 12 mmKerf 6 mmNo. of Teeth 4
Bearing guided intumescent strip cutter for routing the groove for intumescent strip in a frame or door.D 40 mmC 10 mmB 32 mmE 4 mmL 41 mm
Bearing guided intumescent strip cutter for routing the groove for intumescent strip in a frame or door.D 40 mmC 15 mmB 32 mmE 4 mmL 41 mm
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.Two flutes give a clean finish to cut edges.All cutters above and including 9.5mm diameter, have TCT plunge centre...
For housing, grooving and mortising. Features 2mm micrograin Tungsten Carbide tips, for cutting the most abrasive materials to give extra long life.D 5/32 inchD 4 mmC 11 mmShank Diameter 1/4 inch
© Machine Mart 2024, All rights reserved.
Machine Mart Ltd 211 Lower Parliament Street, Nottingham NG1 1GN
Sorry, a problem occurred with the server. Please try again later.
Thank you, you will be emailed when this product comes back in stock.
Enter your email below to receive immediate notification when this item is back in stock.
Please enter an email address.
Please enter a valid email address.