Designed for use on wishbone suspension using access points in the rear suspension arm, this Telescopic spring compressor from Clarke features two pairs of shaped yokes that prevent the coil from bowing,...

This tool allows the user to renew the CV boot of a vehicle without dismantling the CV joint. Manufactured from nylon with a 19mm hexagon bar fitted to the base.

Quality made tool designed to aid fast tensioning and securing of CVJ boot banding material. Simply insert banding, tension using winding mechanism, and then pull over lever to cut the band to length....

The Sealey BSL103 CVJ boot tool installs CVJ boots without removing drive shafts from the vehicle or the CV joint from the drive shaft, thus saving time and any potential damage to the CV joint. While...

Comprehensive set for the removal and installation of nuts on McPherson struts. Covers a large range of vehicle applications.

Sockets manufactured from Chrome Vanadium steel. Permits the removal of the top suspension nut by holding the strut piston, so it doesn’t rotate while turning the nut. The go-through design of the socket...

Used to level the steering wheel before locking into position, prior to checking/adjusting the front wheel alignment. Ideal for use with Four-Wheel Laser Aligners such as Model No. GA70. Self-retaining...

Quickly removes the CV joint from the drive shaft without damaging the joint, and keeps hands free for releasing retaining circlip. Reduces risk of damage to transmission. Saves on labour time and suitable...

Permits the removal of the top suspension nut by holding the strut piston, so it doesn’t rotate while turning the nut. The go-through design of the socket and ratchet allows the extension to pass through...

Steel body CVJ Boot band pliers with 3/8"Sq drive, for the assembly of new stainless steel bands on drive shafts where a torque setting is required.

Universal CVJ boot made from high quality neoprene material suitable for use with air operated boot installation tools. Supplied with fitting kit including clips and cutting guide. Suitable for most car...

For use on 14-23mm diameter track rodsThis track rod end tool is for loosening and adjusting stubborn track rods. The solid forged steel head and jaws allow more torque for less effort while the large...

Designed for the second generation of wheel bearing found on modern vehicles. These bearings are lightweight with an integral mounting flange. They are also pre-loaded with a retaining ring that secures...

Designed for the second generation of wheel bearing found on modern vehicles. These bearings are lightweight with an integral mounting flange. They are also pre-loaded with a retaining ring that secures...

Designed for the installation and removal of slotted bushes on HGV spring suspension. Includes a 12tonne hydraulic cylinder (supplied without hydraulic pump). Installation protects the bush using the parallel...