For producing ovolo and rounding over edge moulds, using a side fence or back fence.D 1/2 inchD 12.7 mmC 23/64 inchC 9 mmR 4.8 mmOverall length 51.5 mmShank Diameter 1/4 inch

Lip and spur dowel drills for use with the Trend Craft Dovetail Jig dowelling template.D 8 mmC 35 mmOL 70 mmShank length 23 mmShank Diameter 1/4 inch

This cutter is for Trend Craft Dovetail Jigs.D 12.7 mmC 20 mmOL 60 mmA 98 degreesShank Diameter 1/4 inch

Bearing guided intumescent strip cutter for routing the groove for intumescent strip in a frame or door.D 24 mmC 10 mmB 16 mmE 4 mmOverall length 58 mmShank Diameter 1/4 inchFire check 30 minutes

Two flute TC cutter giving good chip clearance.D 3/4 inchD 19.1 mmC 19 mmOL 51 mmShank Diameter 1/4 inch

The glazing bar ovolo cutter is bearing guided to speed setting-up and to enable curved frames to be moulded.D 28 mmC 19 mmB 12.7 mmR 10 mmOverall length 70.5 mmShank Diameter 1/4 inch

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.Two flutes give a clean finish to cut edges.All cutters above and including 9.5mm diameter, have TCT plunge centre...

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.Two flutes give a clean finish to cut edges.All cutters above and including 9.5mm diameter, have TCT plunge centre...

For housing, grooving and mortising. Features 2mm micrograin Tungsten Carbide tips, for cutting the most abrasive materials to give extra long life.D 5/32 inchD 4 mmC 11 mmShank Diameter 1/4 inch

For housing, grooving and mortising. Features 2mm micrograin Tungsten Carbide tips, for cutting the most abrasive materials to give extra long life.D 5/16 inchD 8 mmC 19 mmShank Diameter 8 mm

A bearing guided reversible finger jointer, to increase the gluing area for edge to edge joints.

For housing, grooving and mortising. Features 2mm micrograin Tungsten Carbide tips, for cutting the most abrasive materials to give extra long life.D 25/64 inchD 10 mmC 19 mmOL 60 mmShank Diameter 1/4...

By making a second pass at 90 degrees a full corner bead can be cut.D 31.9 mmD2 28.6 mmB 16 mmR 7 mmShank Diameter 1/4 inch

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.D 25/64 inchD 10 mmC 19 mmOL 51 mm

Self-guiding trimmers with bearings mounted on end of cutter.D 3/4 inchD 19.1 mmC 14 mmB 19.1 mmA 90 degreesOverall length 60 mmShank Diameter 1/4 inch