The glazing bar ovolo cutter is bearing guided to speed setting-up and to enable curved frames to be moulded.D 28 mmC 19 mmB 12.7 mmR 10 mmOverall length 70.5 mmShank Diameter 1/4 inch

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.Two flutes give a clean finish to cut edges.All cutters above and including 9.5mm diameter, have TCT plunge centre...

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.Two flutes give a clean finish to cut edges.All cutters above and including 9.5mm diameter, have TCT plunge centre...

For housing, grooving and mortising. Features 2mm micrograin Tungsten Carbide tips, for cutting the most abrasive materials to give extra long life.D 5/32 inchD 4 mmC 11 mmShank Diameter 1/4 inch

For housing, grooving and mortising. Features 2mm micrograin Tungsten Carbide tips, for cutting the most abrasive materials to give extra long life.D 5/16 inchD 8 mmC 19 mmShank Diameter 8 mm

A bearing guided reversible finger jointer, to increase the gluing area for edge to edge joints.

For housing, grooving and mortising. Features 2mm micrograin Tungsten Carbide tips, for cutting the most abrasive materials to give extra long life.D 25/64 inchD 10 mmC 19 mmOL 60 mmShank Diameter 1/4...

By making a second pass at 90 degrees a full corner bead can be cut.D 31.9 mmD2 28.6 mmB 16 mmR 7 mmShank Diameter 1/4 inch

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.D 25/64 inchD 10 mmC 19 mmOL 51 mm

Self-guiding trimmers with bearings mounted on end of cutter.D 3/4 inchD 19.1 mmC 14 mmB 19.1 mmA 90 degreesOverall length 60 mmShank Diameter 1/4 inch

Cuts cleanly without feather edging.D 14.5 mmC 12.5 mmC2 14 mmA 60 degreesShank Diameter 1/4 inch

For coves and part of a rule joint with a 1/4" shank diameter.D 8 mmC 1/2 inchC 12.7 mmR 4 mmOL 46 mm

For producing ovolo and rounding over edge moulds, using a side fence or back fence.D 5/8 inchD 15.9 mmC 13.5 mmR 6.3 mmOverall length 57 mmShank Diameter 1/4 inch

The classic method of producing cabinet panelled door and drawer fronts is made easy with these Profile Scriber sets.D 41 mmC 17 mmC2 6.35 mmB 22 mmR 4 mmShank Diameter 1/4 inchOverall length 81 mmTimber...

Panel raiser cutters for producing the panel for cabinet panelled doors, tool matches our range of profile scribers.D 41 mmD2 7 mmC 12 mmR 12 mmOverall length 52 mmShank Diameter 1/4 inch